Meliconi Gumbody Facile 3 web User Manual download pdf (Page 3)

NOTE: If you don’t receive an SMS on your cell phone or if the message says ERROR / NO CODE, it

means the system has not been able to process the data you have sent. Do not try sending another SMS

use the MANUAL SEARCH instead.

(only to be performed if the speciﬁ c code could not be found)

SETTING CODES USING A MANUAL SEARCH

CHECK

Check that the other buttons correspond to the functions of the original remote control; if not, it is likely

that the code found is incorrect, but is used for a very similar device. In that case, repeat the procedure

from point 2.

If the manual search for the code is successful, obtain the code in use by following the DISPLAY CODE IN

USE procedure and make a note of it inside the battery cover.

NOTE: During the search the indicator stops ﬂ ashing and the remote control exits the programming mode

in the following cases:

• if for 12 seconds the button indicated is not pressed or if another button is pressed

• if the list of codes to ﬁ nd is terminated. If this happens, go to the www.meliconi.com/guide website.

ENTERING THE CODE DIRECTLY

(only to be performed if you know the speciﬁ c code to be set)

1. Switch on the device to be programmed and select a pro-

gram

2. Press and hold down for 6 seconds the device selection

button corresponding to the device you wish to enter the

code for.

3. Release the button. The indicator light will ﬂ ash. Point the

remote control at the device and press the ON/OFF key.

If the device does NOT switch off press the same button

again slowly (it may be necessary to press the button se-

veral times).

4. When the device responds correctly, press OK. Three

long ﬂ ashes indicate that the operation has been carried

out correctly.

6 SEC.

1. Press and hold down for 6 seconds the device selection

button corresponding to the device you wish to enter the

code for.

2. Release the button. The indicator light ﬂ ashes. Imme-

diately enter the speciﬁ c code previously found. (e.g.

1306).

3. Three long ﬂ ashes indicate a correct setting.

6 SEC.

or or

1 2 3 4 5 6 7

No comments

Meliconi Gumbody Facile 3 web User Manual Page 3